PETKUS continuous flow dryers type DW are designed for drying cereals, maize, oilseeds and free flowing granules such as clay minerals and straw granules. Three models are available (1500, 2500, 4000) with capacities from 8 t/h up to 48 t/h (wheat based). The “DW” series of continuous flow dryers are equipped with an efficient stainless steel heat exchanger which separates the flue gas from the drying air. Alternative heating systems, such as steam or hot water heat exchangers, are available on request.

The product enters at the top of the dryer and flows in the direction of the outlet through alternating conical air ducts. During the process, the product is continuously stirred and the hot air from the burner is evenly distributed throughout the product. The required air flow is generated by axial fans located on the roof of the exhaust air duct. The hot air is generated by both the burner and the heat exchanger. The air velocity can be adjusted by means of an air valve at the top of the dryer. The louvers behind the exhaust fans close when the product enters to prevent dust from entering the exhaust air.

Features

• Galvanised sheet steel model
• Low electricity consumption
• Low fuel consumption, as the burner is located in the dryer tower
• Gentle and even drying
• Used with gas or oil burner
• Indirect heating of drying air through heat exchangers
• Exhaust gases from the combustion process are separated from the process air.
• Steam, hot water and thermal oil heat exchangers can be used.
• Three models with different capacities
• High thermal capacity and efficiency
• Tapered air ducts increase capacity by 10-12%
• Tempered warm air duct
• Low dust emissions, complies with EU limits
• Easy and quick assembly, as no scaffolding is needed
• Requires a relatively small site to erect
• Tank with level sensor
• Control panel with touch panel and control software